Draining water from a car door is a quick and easy process that can be done in a few simple steps. In most cases, the water will drain out on its own, but if necessary the door can be opened slightly to help the process along. By following these simple steps, you’ll be able to get your car back to normal in no time!
Disinfect the Water
If the water is dirty or contaminated, it’s important to disinfect it before proceeding. This will help ensure that any bacteria or other harmful contaminants are removed and won’t cause any damage to your car. The easiest way to disinfect the water is to add a small amount of bleach to it and then let it sit for a few minutes. Alternatively, you can also use a water filtration system to remove any contaminants.
Open the Door Slightly
If the water is not draining on its own, you can open the door slightly to help the process along. Be careful not to open the door too much, as this could allow more water to enter the car. Just open it enough so that the water can start to drain out.
Remove Any Remaining Water
Once the majority of the water has drained out, you can remove any remaining water with a sponge or cloth. Be sure to wring out the sponge or cloth before using it so that you don’t add more water to the car. Once all of the water has been removed, you can close the door and dry off any wet areas with a towel.
Find out more about car body shops check out NRC Group.
Check for leaks
Once the doors are clean and dry, it’s a good idea to check for any leaks. If there are any cracks or holes in the door, water could potentially enter the car and cause problems. To check for leaks, simply place a towel under the door and then close it. If water leaks out, you’ll need to repair the door before proceeding.
Wash the Doors
If the doors are dirty, they can be washed with a mild soap and water. Be sure to rinse them off thoroughly so that no soap residue is left behind. Here you can use car wash bucket to easily carry water and cleaning materials. Once they’re clean, you can dry them off with a towel or let them air dry.
Remove the Old Door Cover
The old door cover can now be removed. To do this, simply unscrew the two screws that are holding it in place. The door cover can then be lifted off of the car. If necessary, you can use a screwdriver to pry it off if it’s stuck.
Install the New Door Cover
With the old door cover removed, you can now install the new one. Start by aligning the new cover with the holes on the door. Once it’s in place, screw in the two screws to secure it. That’s it! Your car should now be good as new.
Close the Door Properly
Once the new door cover is in place, be sure to close the door properly. This will help ensure that it stays in place and doesn’t come loose. To close the door properly, simply push it until it’s flush with the car. Once it’s closed, you can check to make sure that the door is secure by trying to open it. If it opens, the door is not secure and you’ll need to repeat the steps.
Re-Wash the Doors
Now that the new door cover is in place, you’ll need to re-wash the doors. This will help remove any dirt or debris that may have gotten onto the doors during the installation process. Be sure to use a mild soap and water so that you don’t damage the door.
Conclusion:
After following these simple steps, you will be able to safely and effectively remove the water from your car door. Remember to disinfect the area afterwards and keep an eye out for any leaks that may occur in the future. If you have any questions or concerns, please do not hesitate to reach out to us. We are more than happy to help.
